LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the oil pan as necessary. Refer to Oil Pan Assemble .
    2. Fig 1: Removing & Installing Oil Pan
    GM1306202Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pan. Refer to Oil Pan Installation .
  3. Loosen the engine support fixture wing nuts in order to lower the engine and engage the engine mounts to the frame.
  4. Remove the engine support fixture. Refer to Engine Support Fixture .
  5. Remove the transmission oil cooler pipe retainer from the engine right side.
  6. Fill the engine with new engine oil. Refer to Engine Oil and Oil Filter Replacement .
  7. Install the A/C compressor bracket with the A/C compressor. Refer to Air Conditioning (A/C) Compressor Installation .
    8. Fig 2: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  8. Install the engine mount lower nuts. Refer to Engine Mount Replacement - Left and Engine Mount Replacement - Right .
    9. Fig 3: Identifying Intermediate Steering Shaft
    GM754891Courtesy of GENERAL MOTORS CORP.
  9. Connect the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement - Upper in Steering Wheel and Column.
  10. Install the power steering hose retainer to the A/C compressor bracket.
  11. Install the engine front cover. Refer to Engine Front Cover Replacement .
scientia non olet · About LEMON Manuals