LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 3 Of 5)) >> Off-Vehicle Repair Instructions - Part 2 >> Oil Pan Assemble

Oil Pan Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    2. Fig 2: View Of Oil Suction Pipe
    GM1210965Courtesy of GENERAL MOTORS CORP.
  2. Install the oil suction pipe.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil suction pipe bolts.

    Tighten:  Tighten the oil suction pipe bolts to 10 N.m (89 lb in).

    4. Fig 3: View Of Oil Pan Scraper And Bolts
    GM1210963Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts.

    Tighten:  Tighten the oil pan scraper bolts to 10 N.m (89 lb in).

    6. Fig 4: Removing & Installing Oil Drain Plug
    GM1210967Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan drain plug and NEW O-ring seal.

    Tighten:  Tighten the oil pan drain plug to 20 N.m (15 lb ft).

    7. Fig 5: Removing & Installing Oil Level/Condition Sensor
    GM1210961Courtesy of GENERAL MOTORS CORP.
  7. Install the oil level/condition sensor.
  8. Install the oil level/condition sensor bolt.

    Tighten:  Tighten the oil level/condition bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals