LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 5 Of 5)) >> Off-Vehicle Repair Instructions - Part 4 >> Air Conditioning (A/C) Compressor Installation

Air Conditioning (A/C) Compressor Installation

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.
    Fig 1: Aligning A/C Compressor Bracket
    GM945879Courtesy of GENERAL MOTORS CORP.
  1. Place the A/C compressor bracket in position to the cylinder block.
  2. Loosely install the A/C compressor bracket bolts.
    3. Fig 2: Locating A/C Compressor Bracket & Bolts
    GM945869Courtesy of GENERAL MOTORS CORP.
  3. Place the A/C compressor in position to the A/C compressor bracket.
  4. Loosely install the A/C compressor bolts through the A/C compressor and A/C compressor bracket into the engine block.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the A/C compressor bracket center bolt.

    Tighten:  Tighten the A/C compressor bracket center bolt to 50 N.m (37 lb ft).

  6. Tighten the A/C compressor bracket upper bolt.

    Tighten:  Tighten the A/C compressor bracket upper bolt to 50 N.m (37 lb ft).

  7. Tighten the A/C compressor bracket lower bolt.

    Tighten:  Tighten the A/C compressor bracket lower bolt to 50 N.m (37 lb ft).

  8. Tighten the A/C compressor front upper and lower bolts.

    Tighten:  Tighten the A/C compressor front upper and lower bolts to 22 N.m (16 lb ft).

  9. Tighten the A/C compressor rear bolt.

    Tighten:  Tighten the A/C compressor rear bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals