LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Tilt Spring - Assemble - Off Vehicle

Tilt Spring - Assemble - Off Vehicle

    Fig 1: Tilting Column To Up Position
    GM293245Courtesy of GENERAL MOTORS CORP.
  1. Use the tilt lever to tilt the column to the UP position.
    2. Fig 2: Spring Guide & Tilt Spring
    GM293250Courtesy of GENERAL MOTORS CORP.
  2. Lubricate the tilt spring with synthetic grease.
  3. Install the spring guide into the tilt spring.
    4. Fig 3: Installing Tilt Spring Onto The Steering Column Support Assembly
    GM293251Courtesy of GENERAL MOTORS CORP.
    CAUTION: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.
  4. Install the tilt spring (1) onto the steering column support assembly (2) and onto the steering column tilt head assembly by using the following procedure:
    1. Install the tilt spring (1) onto the steering column tilt head assembly.
    2. Install the tilt spring (1) onto the post on the steering column support assembly (2).
  5. Remove the tilt lever.
  6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds)  or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
  7. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals