LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift)

Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift)

    Fig 1: Upper Trim Cover & Screws
    GM415299Courtesy of GENERAL MOTORS CORP.
  1. Install the upper trim cover (2) onto the steering column.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Screw the 2 TORX® head screws (1) into the upper trim cover (2).

    Tighten:  Tighten the 2 TORX® head screws to 1.5 N.m (13 lb in).

    3. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS CORP.
  3. Install the lower trim cover onto the upper trim cover in the following way:
    1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
    2. Tilt the lower trim cover up.
    3. Slide the lower trim cover forward until the locking tabs snap into the tab slots.
    4. Fig 3: Lower Trim & Pan Head Tapping Screws
    GM415298Courtesy of GENERAL MOTORS CORP.
  4. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).

    Tighten:  Tighten the 2 pan head tapping screws to 3.5 N.m (31 lb in).

  5. Install the tilt lever into the lower trim cover. Refer to Tilt Lever Replacement - On Vehicle .
  6. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  7. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals