LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4487717Courtesy of GENERAL MOTORS COMPANY

    Install the input speed sensor seal (3).

  2. Install the input speed sensor (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (1) and tighten to 9 N.m (80 lb in)
  4. Connect the input speed sensor electrical connector.
  5. Install the left front wheel house liner. Front Wheelhouse Liner Replacement (LGX) , or Front Wheelhouse Liner Replacement (LTG)
  6. Perform the solenoid valve characterization procedure. Solenoid Valve Characterization Reprogramming
scientia non olet · About LEMON Manuals