LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2019 >> Regal TourX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Engine Mechanical - 3.6L (LGX) - Repair Instructions) >> Repair Instructions >> Camshaft Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2020 Buick Regal and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the camshaft cover as needed. Camshaft Cover Assemble 
  2. Fig 1: Identifying Camshaft Cover, Bolts And Seal With Tightening Sequence
    GM4140321Courtesy of GENERAL MOTORS COMPANY

    Place a bead 8 mm (0.3150 in) in width by 4 mm (0.1575 in) in height of RTV sealant equivalent, on the engine front cover split lines (1). Adhesives, Fluids, Lubricants, and Sealers

  3. Camshaft Cover Seal (2) - Install a NEW seal.
  4. Camshaft Cover (3) - Install
  5. Camshaft Cover Bolt (4) - Loosely install [18x]
    6. CAUTION:

    Refer to Fastener Caution .

  6. Tighten in the sequence shown. 15 N.m (11 lb ft).
  7. Position and install the engine harness to the camshaft cover.
  8. Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Intake - Install
  9. Camshaft Position Actuator Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust - Install
  10. Ignition Coil Replacement - Bank 1 - Install
  11. Positive Crankcase Ventilation Tube @ Camshaft Cover - Connect
  12. Camshaft Housing Cover Insulator Replacement - Right Side  - Install
scientia non olet · About LEMON Manuals