LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2018 >> Regal GS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 9T50 (M3D) And 9T60 (M3T) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Control Replacement (With Base)

Transmission Control Replacement (With Base)

GM4196225Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Front Floor Console Replacement
  2. Front Floor Console Rear Air Front Duct Replacement
  3. WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  4. Range Selector Lever Cable@Transmission Control - Disconnect - Automatic Transmission Range Selector Lever Cable Replacement 
  5. Disconnect the electrical connectors and the wiring harness retainer
1 Transmission Control Nut[4x]
Tighten 
9 N.m (80 lb in)
2 Transmission Control