Inspection/Maintenance (I/M) System DTC Table (LEA)
WARNING: This page is about a different variant/trim than selected.
| System | DTCs Required to Set System Status to YES |
|---|---|
| If an I/M System Status indicator did NOT update to YES during the Inspection/Maintenance Complete System Set Procedure , review each indicator and reference this table to determine each DTC associated with the I/M System Status Indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs, which if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the Conditions for Running for each DTC listed below will allow the I/M System Status Indicators to transition to YES. | |
| Catalyst | DTC P0420 |
| EVAP | |
| Fuel | DTC P219A |
| Oxygen Sensor | DTC P0133, P013A, P013B, P013E, P013F, P015A, P015B, P2270, or P2271 (LUK) |
| Oxygen Sensor Heater | |
| Camshaft System | DTC P0011 or P0014 |