LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2015 >> Regal GS, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement (LUK) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Air Cleaner Assembly
    GM2581179Courtesy of GENERAL MOTORS COMPANY
  1. Remove the air cleaner assembly (1). Refer to Air Cleaner Assembly Replacement .
    2. Fig 2: Identifying Drive Belt
    GM1809412Courtesy of GENERAL MOTORS COMPANY
  2. Remove the drive belt (1). Refer to Drive Belt Replacement .
  3. Remove the wheelhouse splash shield. Refer to Front Compartment Splash Shield Replacement .
    4. Fig 3: Power Brake Booster Vacuum Rear Pipe Quick Connect And Retainer
    GM2213625Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect and reposition the vacuum booster rear pipe (2). Refer to Power Brake Booster Vacuum Rear Pipe Replacement (2.0L)
    5. Fig 4: Crankshaft Balancer And Bolt
    GM1811400Courtesy of GENERAL MOTORS COMPANY
  5. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
    6. Fig 5: Engine Front Cover Bolts
    GM1578292Courtesy of GENERAL MOTORS COMPANY
  6. Remove the engine front cover bolts.
    7. Fig 6: Engine Front Cover
    GM1578293Courtesy of GENERAL MOTORS COMPANY
  7. Remove the engine front cover to water pump bolt.
  8. Remove the engine front cover.
    9. Fig 7: Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS COMPANY
  9. Remove and discard the engine front cover gasket.
scientia non olet · About LEMON Manuals