Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the lower tensioner pivot bolt (2) into the tensioner (1).
- Position the tensioner assembly in place.
- Install the drive belt tensioner bolts (2, 3).
- Tighten the bolts (2, 3) in sequence. Make sure that the torque wrench and J-45025 are in a straight line to ensure proper torque at the bolt.
- Tighten the top bolt to 22 N.m (16 lb ft).
- Use the J-45025 adapter , to tighten the tensioner pivot bolt to 42 N.m (31 lb ft).
- Install the drive belt. Refer to Drive Belt Replacement .
- Install the right side engine mount. Refer to Engine Mount Replacement .
NOTE:
Install the accessory drive belt tensioner and bolt as an assembly.
WARNING:
To avoid personal injury, only remove the tensioner shipping clip when the tensioner is properly mounted to the engine and the accessory drive belt is in place and properly routed.
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Drive Belt Tensioner Pivot Bolt Caution .
NOTE:
Use J-45025 adapter in combination with a 3/8 drive torque wrench to reach & achieve proper torque on tensioner pivot bolt. Make sure that the torque wrench and the J-45025 adapter are in a straight line to ensure proper torque at the bolt.