Ignition Key Cannot Turn or Sticks in Any Position
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column System Description and perform the necessary inspections? | Go to Step2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that the ignition key sticks or cannot turn in any position. Is the key functioning correctly? |
System OK | Go to Step3 |
| 3 | Inspect for an incorrect, worn, or damaged ignition key. Is the ignition key incorrect, worn, or damaged? |
Go to Step7 | Go to Step4 |
| 4 | Inspect for a faulty ignition lock cylinder. Is the ignition lock cylinder damaged? |
Go to Step8 | Go to Step5 |
| 5 | Inspect the ignition and start switch assembly for damage. Is the ignition and start switch assembly damaged? |
Go to Step9 | Go to Step6 |
| 6 | Inspect the ignition and start switch housing for looseness. Is the ignition and start switch housing loose? |
Go to Step10 | Go to Step11 |
| 7 | Replace the ignition key. Did you complete the repair? |
Go to Step11 | |
| 8 | Replace the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement
. Did you complete the repair? |
Go to Step11 | |
| 9 | Replace the ignition and start switch. Refer to Ignition and Start Switch Replacement (With BTM)
. Did you complete the repair? |
Go to Step11 | |
| 10 | Tighten or replace the ignition and start switch housing. Refer to Ignition and Start Switch Housing Replacement Did you complete the repair? |
Go to Step11 | |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step2 |