Front Seat Cushion Cover Replacement (2-Way Power)

Fig 1: Front Seat Cushion Cover (2-Way Power)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning WARNING: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction. Preliminary Procedures Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection . Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation (Oshawa 2/4/6-Way Hybrid, 6-Way Sport) . Remove the driver or passenger seat recliner lever. Refer to Driver or Passenger Seat Recliner Lever Replacement . Remove the driver or passenger seat adjuster finish cover. Refer to Driver or Passenger Seat Adjuster Finish Cover Replacement (8-Way-Power) . Remove the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) . Remove the front seat outer adjuster finish cover. Refer to Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (8-Way Power) . When working with the passenger seat re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References
1	Front Seat Cushion Pad Procedure Clip out the cushion cover at seat frame rear side. Clip out the cushion cover at seat frame left side. Clip out the cushion cover at seat frame right side. Clip out the cushion cover at seat frame front side. Remove the seat cushion pad with the cushion cover.
2	Front Seat Cushion Cover Procedure Remove the hog rings from the under side of the seat cushion. Pull the cushion cover off the cushion pad.

Callout

Component Name

WARNING:

To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

Preliminary Procedures

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation (Oshawa 2/4/6-Way Hybrid, 6-Way Sport) .
Remove the driver or passenger seat recliner lever. Refer to Driver or Passenger Seat Recliner Lever Replacement .
Remove the driver or passenger seat adjuster finish cover. Refer to Driver or Passenger Seat Adjuster Finish Cover Replacement (8-Way-Power) .
Remove the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement (2/4/6-Way Hybrid, 6-Way Hybrid Sport) .
Remove the front seat outer adjuster finish cover. Refer to Driver or Passenger Seat Outer Adjuster Finish Cover Replacement (8-Way Power) .
When working with the passenger seat re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References

Front Seat Cushion Pad

Procedure

Clip out the cushion cover at seat frame rear side.
Clip out the cushion cover at seat frame left side.
Clip out the cushion cover at seat frame right side.
Clip out the cushion cover at seat frame front side.
Remove the seat cushion pad with the cushion cover.

Front Seat Cushion Cover

Procedure

Remove the hog rings from the under side of the seat cushion.
Pull the cushion cover off the cushion pad.