Headlamp and Bumper Fascia Mounting Panel - Front

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Headlamp & Bumper Fascia Mounting Panel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the front fascia. Refer to Fascia, Absorber, Reinforcement Replacement - Front Bumper . Remove the headlamps. Refer to Headlamp, Fog Lamp, Turn Signal Lamp, Side Marker Lamp Replacement - Front . Remove the radiator support sight shield. Refer to Radiator Support Sight Shield Replacement .
1	Retainer, Headlamp Mounting Panel (Qty: 2) Tighten: 2 N.m (18 lb in)
2	Screw, Headlamp Mounting Panel (Qty: 2) Tighten: 2 N.m (18 lb in)
3	Screw, Headlamp Mounting Panel (Qty: 2) Tighten: 2 N.m (18 lb in)
4	Screw, Headlamp Mounting Panel (Qty: 2) Tighten: 2 N.m (18 lb in)
5	Panel. Headlamp Mounting Panel