Installing the sealing sleeve for the transmission housing

• Make sure that the lug (1) of the sealing sleeve is not damaged during re-installation.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the sealing rings (1) of the sealing sleeves during re-installation.

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lightly place the sealing sleeve (1) in arrow direction with the lug in the inner surface.
• Turn the sealing sleeve (1) until the lug is inserted in the groove of the transmission.
• Slide in sealing sleeve (1) up to the stop.

  The lug on the sealing sleeve (1) must not be damaged! 

• Remove the special tool 0 494 213 (24 2 390) .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock the slide (2).
• Position and tighten the screw (1).
• Replace screw.

Parts:  Screw

Courtesy of BMW OF NORTH AMERICA, INC.

• Slide connector (1) in the arrow direction and lock it by turning it.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE OIL VOLUME RESERVOIR (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z, GA8HP95Z) .
• Refer to INSTALLING TRANSMISSION OIL PAN (ALL-WHEEL DRIVE VEHICLE) (GA8HP50Z, GA8HP51Z) .
• Refer to ACTIVATING ELECTRICAL SYSTEM .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to INSTALLING TRANSMISSION CROSS MEMBER .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .