Installing the adjuster for the thigh support
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUES SPECIFICATION
| Drive for seat cushion tilt adjustment to seat | ||
|---|---|---|
| Nut M6 | Tightening torque | 14 Nm |
| Stud | Tightening torque | 8 Nm |
- Tighten threaded bolt (1) .
TIGHTENING TORQUES SPECIFICATION
| Adjuster for thigh support | ||
|---|---|---|
| Nut M6 | Tightening torque | 7 Nm |
| Stud | Tightening torque | 15 Nm |
- Counter support the bolts (2) and tighten the associated nuts.
TIGHTENING TORQUES SPECIFICATION
| Adjuster for thigh support | ||
|---|---|---|
| Nut M6 | Tightening Torque | 7 Nm |
| Stud | Tightening Torque | 15 Nm |
- Connect connector (4) .
- Clip in wiring harness (3) .
- Attach spring packet (1) .
Follow-up work
- Refer to FITTING THE SEAT COVER WITH THE CUSHION FOR THE FRONT SEAT .
- Refer to INSTALLING THE SUPPORT FOR THE OUTER COVER ON THE FRONT SEAT .
- Refer to INSTALLING OPERATING UNIT FOR THE SEAT ADJUSTMENT .
- Refer to INSTALLING OUTER COVER ON FRONT SEAT .
- Refer to INSTALLING INNER COVER ON FRONT SEAT .
- Refer to INSTALLING FRONT SEAT .