Perform chassis alignment check
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Precondition
- Only wheel and tire combinations approved by BMW are attached to the vehicle. The tread depths on the left and right differ by a maximum of 2 mm.
NOTE:
TECHNICAL INFORMATION
Basically a wheel alignment must always be carried out with ride height measurement without vehicle load.
For additional information see: 32 00 155 KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLE .
Carry out wheel alignment with vehicle load up to design position , if the technical prerequisites for a wheel alignment with ride height measurement without vehicle load are not fulfilled or if it is a vehicle involved in an accident.
Basically a wheel alignment must always be carried out with ride height measurement without vehicle load.
For additional information see: 32 00 155 KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLE .
Carry out wheel alignment with vehicle load up to design position , if the technical prerequisites for a wheel alignment with ride height measurement without vehicle load are not fulfilled or if it is a vehicle involved in an accident.
NOTE:
TECHNICAL INFORMATION
Before every toe adjustment and after replacing the electromechanical steering gear (EPS), a commissioning (initialization) of the electromechanical steering gear (EPS) must be performed.
Before every toe adjustment and after replacing the electromechanical steering gear (EPS), a commissioning (initialization) of the electromechanical steering gear (EPS) must be performed.
Preliminary work
- Refer to PRELIMINARY WORK BEFORE WHEEL ALIGNMENT .
- Refer to SHIFTING VEHICLE INTO NORMAL POSITION .
- Refer to SHIFTING VEHICLE INTO DESIGN POSITION .
- Perform the introductory wheel alignment in accordance with equipment manufacturer's instructions.
- If necessary, adjust the front axle and the rear axle.
- Perform the final wheel alignment in accordance with equipment manufacturer's instructions.
- Save and print out test record.
Follow-up work
- Refer to REMOVING THE WHEEL ALIGNMENT EQUIPMENT .