Install the DSC control unit
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Carefully attach the DSC control unit (5) to the hydraulic unit.
- Replace screws (1)
to (4)
.
Parts: Screws
- Tighten the screws (1) to (4) step by step in this sequence.
TIGHTENING TORQUES SPECIFICATION
| DSC control unit on hydraulic unit | ||
|---|---|---|
| Screw Replace screws. Screw in screws and evenly tighten crosswise. |
1. tightening torque | 1.5 Nm |
| 2. tightening torque | 2.5 Nm | |
| Position the 3rd tightening torque | 3.5 Nm | |
- Install holder (2) .
- Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Hydraulic control unit to holder | ||
|---|---|---|
| M6 Replace screws. |
tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE HYDRAULIC UNIT .
- Refer to INSTALLING THE LEFT FRONT-END STRUT .
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .