Install brake guard plate, front
- Install brake guard plate (2) .
- Replace screws (1)
.
Parts: Screws
- Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake guard plate at front swivel bearing | ||
|---|---|---|
| M6x12 Replace screw. |
tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE FRONT BRAKE DISCS .
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (BRAKE HIGH) .
- Refer to INSTALLING FRONT PADS (HIGH BRAKE) .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (HIGH BRAKE) .