Installing the front brake discs
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
- Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disk (2) .
- Replace screws (1)
.
Parts: Screws
- Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake disc to front wheel hub | ||
|---|---|---|
| M8 Replace screw. |
Tightening torque | 16 Nm |
- Mount the brake caliper in the arrow direction.
- Insert screws (1) and tighten.
- Replace screws (1)
.
Parts: Screws
TIGHTENING TORQUES SPECIFICATION
| Brake caliper/brake anchor plate at front swivel bearing | ||
|---|---|---|
| M12 Replace screw. |
Tightening torque | 130 Nm |
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (BRAKE HIGH) .
- Refer to INSTALLING FRONT PADS (HIGH BRAKE) .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (HIGH BRAKE) .