Installing the lower front wishbone
NOTE:
RISK OF DAMAGE
Failure to comply with the specification.
Component damage.
Failure to comply with the specification.
Component damage.
- All specifications must be observed and complied with.
NOTE:
TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.
Incorrect assembly is possible. Ensure correct installation position.
- Position the lower front wishbone on the wheel carrier.
- Guide the lower front wishbone into the rear axle support.
- Replace screws (1) and (2).
Parts: Screws
- Tighten screw (1) by hand.
The screw connection is tightened with the torque wrench later in the NORMAL POSITION .
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front lower wishbone to rear axle support | ||
| M12 Replace screw. | Tightening torque | 100 Nm |
Follow-up work
- Refer to INSTALLING THE LEFT OR RIGHT THRUST FIELD .
- Refer to INSTALLING TANK COVER .
- Refer to INSTALLING THE REAR LEFT WHEEL .
- Refer to MEASURING THE RIDE HEIGHT OF REAR AXLE AND ADJUSTING THE NORMAL POSITION .
- Refer to TIGHTENING THE SCREW CONNECTION OF THE LOWER FRONT CONTROL ARM TO THE WHEEL CARRIER .
- Refer to PERFORMING CHASSIS ALIGNMENT CHECK .