Installing the cross connection at the top rear
- Install cross connection (3) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Rear cross connection on lock support | ||
|---|---|---|
| Hexagon screw M8x20 Replace screws |
Tightening torque | 19 Nm |
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Rear cross connection on body | ||
|---|---|---|
| M10x45 hexagon bolt Replace screws |
Tightening torque | 56 Nm |
- Position the holder (2) on the cross connection (3) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Holder on mount | ||
|---|---|---|
| M6 screw | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE CROSS CONNECTION UPPER SECTION .
- Refer to CLOSING THE ENGINE COMPARTMENT LID .