Install alternator
- Slightly push back the threaded support bushing (2) in the arrow direction to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support bushing (2) .
- Push back the threaded support bushing (2) using screw (1) .
- Once again unscrew the screw (1)
from the threaded support bushing (2)
.
- Feed in and install the alternator (1) .
- Tighten the screws (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Alternator on component carrier | ||
|---|---|---|
| M10x75 | tightening torque | 38 Nm |
| M10x125 | tightening torque | 38 Nm |
| M10x90 | tightening torque | 38 Nm |
- Fasten the clamp (arrow) to the alternator (4) .
- Feed in and position the positive battery cable (3) .
- Tighten nut (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to the alternator | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Connect connectors (1)
and lock.
The connector (1) must engage audibly.
- Put drive belt (1)
onto the belt pulley (2)
of the alternator.
- Check the drive belt for the alternator (1)
for the correct fit.
- Raise the preload with standard tools (1) on the belt tensioner in the arrow direction .
- Feed out the special tool 0 496 268 (11 0 390) from the belt tensioner and remove.
Follow-up work
- Refer to INSTALLING FAN COWL .
- Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
- Refer to INSTALLING THE RIGHT INTAKE FILTER HOUSING (FRONT-END STRUT REMOVED) .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE CLEAN AIR PIPE FOR CYLINDERS 1 TO 3 .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING THE BOTTOM FRONT RIGHT SIDE COVER .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .
- Refer to WHEN REPLACING THE ALTERNATOR/ALTERNATOR REGULATOR: RESET GENERATOR STATISTICAL DATA .