Install the stiffening plate
- Position thrust field (3).
- Replace screws (2).
Parts: Screws
- Tighten the screws (2).TIGHTENING TORQUE SPECIFICATIONS
Thrust field to front axle support M10 Replace screw Tightening torque 56 Nm Angle of rotation 90° - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Thrust field to heat shield Screw Tightening torque 3 Nm Securing the left and right thrust field to the door sill
NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.NOTE: Perform the steps on the right and left side. - Version A (G80):
Replace the screw (1).
Parts: Screw
Tighten down screw (1).
- Version B (G82/G83):
Replace screws (1).
Parts: Screws
Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONSThrust field to door sill M10 Replace screw. Tightening torque
Angle of rotation56 Nm
90°NOTE: Perform the steps on the right and left side. - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Cover, steering unit screw Tightening torque 3 Nm - Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
Wheel arch trim panel, front Thermoplastic hexagon screw Tightening torque 2.6 Nm
Follow-up work
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .