Installing intake silencer housing

• Install intake silencer housing.
• Tighten down screws (4).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Intake silencer on vertical strut/deformation element
  M6	Tightening torque	6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect air intake duct (3) to the intake filter housing.
• Attach the clean air pipe to the intake filter housing.
• Tighten clamp (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Clean air pipe to intake silencer and throttle valve
  Screw clamp	Tightening torque	3 Nm

• Clip in control unit (1) on the intake filter housing.

Follow-up work 

• Refer to INSTALLING SUPPORT FOR THE REAR BUMPER PANEL .
• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING NUMBER PLATE LIGHT .
• Refer to MOUNTING LICENSE PLATE .