Install support for the rear bumper panel

• Mount the support (4) for the rear bumper panel.
• Hand-tighten the bolts (2) and nuts (1).
• Hand-tighten the bolts (3).
• Tighten nuts (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Support for bumper cover, rear
  M10	Tightening torque	36 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Support for bumper cover, rear
  M8	Tightening torque	15 Nm

• Clip in the holder (2) on the support for the rear bumper panel.
• Insert the wiring harness (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING REAR BUMPER PANEL .
• Refer to INSTALLING NUMBER PLATE LIGHT .
• Refer to MOUNTING LICENSE PLATE .