Install brake booster (vehicles with automatic transmission)

Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the brake booster (1) into the firewall.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the nuts (1) and tighten.
• Replace nuts.

  Parts  : Nuts

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake booster to pedal assembly console
  M8 Retighten 1x on brake booster after 10 min. Replace nuts.	tightening torque	22 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Lock brake pedal (1) in place in the arrow direction with the brake booster.

  Ensure that the brake pedal is completely locked with the brake booster!

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the check valve (1) in the brake booster in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

• Install air duct (1).

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
• Refer to INSTALLING THE TANDEM BRAKE MASTER CYLINDER (VEHICLES WITH AUTOMATIC TRANSMISSION) .
• Refer to INSTALLING THE EXPANSION TANK (VEHICLES WITH AUTOMATIC TRANSMISSION) .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .