Install front brake caliper
- Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2).
TIGHTENING TORQUE SPECIFICATIONBrake hose to brake caliper, front tightening torque 17 Nm - Make sure the brake hose is not twisted and resting on components attached to the body.
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to GREASE THE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER USING BRAKE PAD PASTE (17 INCH BRAKE) .
- Refer to INSTALLING FRONT BRAKE PADS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .