Installing the support for the front bumper cover at the bottom

• Thread in the support for the bumper cover (2).
• Position all screws and center the support for the bumper cover (2).
  NOTE: Perform the steps on the right and left side.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bottom support on front axle support adapter
  M8x70 screw
  	Tightening torque	19 Nm

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the right and left side.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Vertical connection to support for bumper cover
  M6x20 screw
  	Tightening torque	11.8 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
• Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .