Installing the fog light bracket on the left and right

Installing fog light support 

• Correctly position the fog light bracket (3) and engage at detents (arrows).
• Tighten down screw (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front fog lamp holder to bumper panel
  screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

• Mount blind rivet (1) using the special tool  0 496 521 (00 2 230)  .
• Position holder (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front fog lamp holder to bumper panel
  screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .