Install headlight
WARNING:
Work on components with requirements for a secure energy supply
Ensure proper function after a repair
Ensure proper function after a repair
- Lines are allowed to have only one repair area.
- Notices in the diagnostic system circuit diagrams must be observed.
NOTES ON THE CONTENT AND HANDLING OF DIAGNOSIS DOCUMENTS IN ISTA
- When components are replaced, the notices in the applicable BMW parts catalogue must be observed.
Checking blocking of the horizontal setting
- Insert and position the headlights (2).
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Front light combination, top Screw tightening torque 8 Nm - Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Front light combination, bottom Screw tightening torque 5 Nm - Connect connectors (1) and lock.
- Position trim panel (3).
- Install the expanding rivet (2).
- Install the seal (1).
- Remove the adhesive tape in area (1).
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to ADJUSTING HEADLIGHTS .