Installing the front bumper cover

• Guide in and position bumper cover (1) from the front with a support person.
• Snap bumper cover (1) into all the locks in the area of dotted line (2).

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the left and right side.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front bumper cover on side wall
  Hexagon screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the left and right side.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front bumper cover on side wall
  Hexagon screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

• Connect and lock plug connections (1) in the left wheel well.

  Courtesy of VOLVO CARS CORPORATION

• Connect and lock plug connection (1) in the right wheel well.

  Courtesy of VOLVO CARS CORPORATION

• Connect and lock plug connection (1) in the bottom right wheel well.

  Courtesy of VOLVO CARS CORPORATION

  NOTE: Perform the steps on the left and right side.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front light combination on the front panel
  Combination clamping screw
  	Tightening torque	8 Nm

  Courtesy of VOLVO CARS CORPORATION

• Connect the plug connections (2) and lock.
• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front bumper cover on side wall
  Hexagon screw
  	Tightening torque	3 Nm

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE FRONT HOOD SEAL .