When replacing the glove box lid
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE SIDE PANEL ON THE RIGHT DASHBOARD .
- Refer to REMOVE RIGHT FOOTWELL TRIM .
- Refer to REMOVING GLOVE BOX LIGHT .
- Refer to REMOVE GLOVE COMPARTMENT .
- Refer to REMOVE GLOVE BOX LID .
- The closure of the glove box lid and the lock cylinder cannot be removed without destroying them and must always be replaced .
Assembling the lock cylinder
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Sort the enclosed guard controls (1) as per the graphic.
X = number embossed on the guard control (1)
Y = installation position in the lock cylinder
NOTE:
The description is for one component only. The procedure is identical for all further components.
- Insert the spring (1) into the lock cylinder (2).
- Insert and engage the guard control (1) with the lowest embossed number X
into position Y
of the lock cylinder (2).
The guard control engages audibly.
Check
- Insert the ignition key (1) into the lock cylinder (3).
- Check whether the guard control (2) is flush with the housing.
Result
» The guard control (2) is not flush with the housing (B).
Measure
- Press out the guard control (2) from the lock cylinder (3) using a suitable tool.
Measure
- Repeat the operations using the guard control with the next higher number X , until the guard control is flush with the housing (A).
- Insert the lock cylinder (1) with the ignition key in the glove box lock (2) and press to engage.
- Carefully insert the glove box lock (1) in the glove box lid (2) and lock.
Follow-up work
- Refer to INSTALL GLOVEBOX COVER .
- Refer to INSTALL GLOVE COMPARTMENT .
- Refer to INSTALLING THE GLOVE BOX LIGHT .
- Refer to Refer to INSTALL RIGHT FOOTWELL TRIM .
- Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .