Install the rear blower
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed the rear blower (2) into the center console (3) and install.
NOTE:
Fasten the adjacent threaded plate for the screws (1) in the center console (3) from the top.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear blower to center console | ||
|---|---|---|
| screw | Tightening torque | 1.5 Nm |
- Correctly route the cable (2) and engage with the cable brackets (3).
- Connect the connector (1) for the rear blower and lock.
- Connect plug (1).
- Position the interior antenna (2) correctly and slide in the direction of the arrow until the detent (3) engages.
- Feed in the air duct (1) on the guides (3) from the top.
- Correctly slide the air ducts (1) at bottom onto the rear blower (2).
- Route the cable (1) correctly.
- Engage the cable bracket (2).
Follow-up work
- Refer to INSTALLING THE FRONT STORAGE COMPARTMENT .
- Refer to INSTALLING THERMOELECTRIC COOLING AND HEATING SYSTEM FOR A CUP HOLDER .
- Refer to INSTALL THE CENTER CONSOLE .
- Refer to INSTALL THE CUP HOLDER .
- Refer to INSTALLING THE CENTER ARMREST .
- Refer to INSTALLING THE CENTER CONSOLE TRIM .
- Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to INSTALLING THE CARPET ON THE CENTER CONSOLE AT LEFT AND RIGHT SIDES .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .