Install rear bumper panel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bumper cover (3).
Guide in bumper cover (3) and thereby connect and lock all plugs.
- Insert bumper cover (3) in the guides (2) and engage on the snap-in lugs (1).
NOTE:
Perform the steps on the right and left side.
- Lock in bumper cover in the area of the side panel on the detents.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
- Only for G07:
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
NOTE:
Perform the steps on the right and left side.
- Check the clip (2), it must not damaged or missing.
Clip, (2) always install with the sealing ring .
- Check detents (3), they must not be damaged or missing.
- Clip in the wheel arch trim (1) with the clip (2).
- Engage the wheel arch trim (1) into the detents (3) in the area of the bumper cover.
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
- Loosen screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
Follow-up work
- Refer to INSTALLING REAR REFLECTOR .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .