Install luggage compartment floor covering
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Install the luggage compartment floor covering (1), engage at the rear at the detents (3) and lock at the handle (2).
Installing front luggage compartment floor trim panel
- Check the clips (3) for damage and availability.
Damaged or missing clips (3) must be replaced.
- Install front luggage compartment floor covering (2) and lock in on the clips (3).
- Tighten screws and mount the covers (1).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment floor covering on holder | ||
|---|---|---|
| Oval-head screw | Tightening torque | 15 Nm |
Installing the luggage compartment floor covering (electrical roller cover for luggage compartment)
Prerequisite
The electrical roller cover for luggage compartment must be up. Run it up If applicable.
- Feed in the luggage compartment floor covering (2) and correctly position and lock on handle (3).
- Tighten the screws and close the covers (1).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment floor covering on holder | ||
|---|---|---|
| Oval-head screw | Tightening torque | 15 Nm |
- Fold up the lid (1) and connect the connector (2) and lock.
- Lift the luggage compartment floor covering.
NOTE:
Perform the steps on the right and left side.
- Slide the clamp (1) back from the removal position (2) again.
- Insert the gas pressure spring (3) onto the ball head and lock.
Installing the luggage compartment floor covering (with 3rd row of seats)
- Correctly position the luggage compartment floor covering (2) and lock on handle (3).
- Tighten the screws and close the covers (1).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment floor covering on holder | ||
|---|---|---|
| Oval-head screw | Tightening torque | 15 Nm |