Installing support for front bumper cover
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Guide in the support for the front bumper cover together with the support from below and position correctly.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front bumper bracket to engine mount | ||
|---|---|---|
| Hexagon screw with flange | Joining torque | 100 Nm |
| Angle of rotation | 180° | |
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Hood lock support to support for bumper cover | ||
|---|---|---|
| Hexagon screw M8x20 |
Tightening torque | 19 Nm |
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Bottom support on front axle support adapter | ||
|---|---|---|
| M8x70 screw | Tightening torque | 19 Nm |
- Attach the wiring harness to the support for the bumper cover at the front.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Hood lock support to support for bumper cover | ||
|---|---|---|
| Hexagon screw M8x20 |
Tightening torque | 19 Nm |
- Attach the wiring harness (1) to the support for the front bumper cover.
- Check the impact absorber (3) for damage.
Replace damaged impact absorber (3).
- First attach the impact absorber (3) at the bottom, then press it in at the top.
- Mount the expanding rivets (2).
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING FANFARE HORN, RIGHT .
- Refer to INSTALLING LEFT FANFARE HORN .
- Refer to INSTALL LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING AIR DUCT .
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSERT TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALL FRONT ORNAMENTAL GRILLE .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .