Install front underbody protection
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment.
Different variants may be installed depending on the vehicle equipment.
- Insert front underbody protection (1) and position correctly.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield/frame | ||
|---|---|---|
| Hexagon screw | tightening torque | 3 Nm |
Installing the front skid plate
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Feed in and position the front skid plate.
- Tighten down screws (2) and (1).
TIGHTENING TORQUE SPECIFICATIONS
| Skid plate at the front to front subframe | ||
|---|---|---|
| M8 | Tightening torque | 19 Nm |
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield/frame | ||
|---|---|---|
| Hexagon screw | tightening torque | 3 Nm |