Install bumper cover, front

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Install the bumper cover (2) and engage in the detents in the area of the dashed line.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Upper bumper cover on air flap control
screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Perform the steps on the left and right side.

Clip the bumper cover (2) upwards into the detents.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Front bumper cover on side wall
Hexagon screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the plug (1) into the left wheel well.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and lock the plug (1) into the right wheel well.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Undershield/frame
Hexagon screw	tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
Refer to INSTALL FRONT ORNAMENTAL GRILLE .