Installing the left throttle body

Prepare the throttle body 

• Replace the seal (1)  .

Parts:  Seal

Courtesy of BMW OF NORTH AMERICA, INC.

• Replace sealing ring (2)  .

  Parts:  Sealing ring

• Connect connectors (1)  and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

• Position throttle body (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Throttle body to intake manifold
  screw	Tightening torque	7 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
• Refer to CLOSING THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING THE FRONT-END STRUT .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .