Remounting the headlight bracket
NOTE:
Description is for left component only. Procedure on the right side is identical.
Removing headlight brackets
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Unclip retaining clips (1) in the marked areas and remove them to the front.
- Remove holder (2) on the headlight to the front in the arrow direction.
Installing the bracket on the headlight
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the holder (2) on the headlight against the arrow direction and snap it in.
- Clip in the retaining clips (1) in the marked areas.
Follow-up work
- Refer to INSTALL HEADLIGHT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .
- Refer to ADJUSTING HEADLIGHTS .