Installing the belt pulley on the torsional vibration damper
- Position the belt pulley (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Belt pulley on torsional vibration damper | ||
|---|---|---|
| M10 screw | Tightening torque | 40 Nm |
Follow-up work
- Refer to INSTALL DRIVE BELT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .