Installing front brake caliper (17-inch low brake)

• Fit and tighten brake hose (1)  on brake caliper.

  If necessary, grip at knurling (2).

  TIGHTENING TORQUES SPECIFICATIONS
  
  

  Brake hose to brake caliper, front
  tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the brake hose is not  twisted and resting on components attached to the body.
• If required, attach brake hose to the holder (3).

Follow-up work 

• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to GREASE THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH THE BRAKE PAD PASTE .
• Refer to INSTALLING FRONT BRAKE PADS .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
• Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .