Install the rear window
- Provide two glue cartridges.
- Prepare a glue cartridge with the standard jet nozzle C.
- Apply bead joint in area (1).
- Apply adhesive bead within the mark on the rear window
TECHNICAL DATA SPECIFICATION
| Adhesive bead | |
| b = Width h = Height |
7 mm... 9 mm 11 mm... 13 mm |
- Carefully perform the following actions on rear window (1) with suction lifters:
- Bring it parallel to C-pillar
- Apply and press at the bottom on the seal
- Align sides evenly
- Evenly press all around and engage at the hook and loop tape (dual-lock tape)
- Ensure that the seal (2) is evenly applied on the trunk lid (3).
- Secure rear window (1) with adhesive tap on the roof.
- Connect the connector (2) and attach the cable clip.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Ground strap to trunk lid | ||
| Oval-head screw | Tightening torque | 6.8 Nm |
Follow-up work
- Install rear window WIPER MOTOR .
- Install the rear wiper WIPER ARM .
- Install lower part of REAR SPOILER .
- Install rear SPOILER .
- Install the tailgate TRIM PANEL .
- Install the trunk lid LIGHT .
- Install the power tailgate SWITCH .
- Install both trunk lid COVERS .
- Mount both side rear window frame TRIMS .
- Install the top rear window frame TRIM .