Install the oil vacuum pump
- Feed oil vacuum pump (1) in the drive chain (2) and position.
- Replace screws (1).
Parts: Screws
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Oil vacuum pump to crankcase M8
Replace screw.Joining torque 15 Nm Angle of rotation 45°
Follow-up work
- Refer to REFITTING ENGINE OIL PAN .
- Refer to INSTALLING STARTER MOTOR
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE OIL PAN .
- Refer to RAISE THE FRONT AXLE SUPPORT AND FASTEN IT .
- Refer to TAKE ENGINE OUT OF INSTALLATION ORIENTATION .
- Refer to SECURE THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to FASTEN ELECTRIC COOLANT PUMP AND COOLANT HOSES TO THE FRONT AXLE SUPPORT .
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to INSTALLING THE COVER PANELS ON THE FRONT AXLE ON THE RIGHT AND LEFT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to TOPPING UP THE MOTOR OIL
- Refer to INSTALLING THE OIL FILLER CAP
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS
- Refer to CHECK ENGINE OIL LEVEL .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING COVER ON EXHAUST SYSTEM .
- Refer to TAKE HOOD OUT OF THE SERVICE POSITION .