Remove right engine mount
Preliminary work
- Refer to REMOVING THE UPPER FIREWALL COVER PANEL .
- Refer to REMOVING SUSPENSION CROSS-BRACE .
- Refer to SUCTIONING THE AIR CONDITIONING .
- Refer to EVACUATING THE AIR CONDITIONING .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE INTAKE MANIFOLD FOR INTAKE SILENCER HOUSING .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING THE SERVOMOTOR FOR THE ECCENTRIC SHAFT .
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE FILLING HOSE OF THE WASHING LIQUID CONTAINER .
Precondition
Heating and air conditioning system has been drawn off.
CAUTION:
Residual pressure in the heating and air conditioning system
.
Injury hazard!
Injury hazard!
- Wear safety goggles and protective gloves when disconnecting the refrigerant line.
- Close the refrigerant lines with seal plugs.
- Prepare the special tool 2 414 691 with the special tool 2 357 071 .
- Attach special tool 2 414 691 to front axle support and align special tool 2 357 071 correctly under the oil sump and then tighten.
- Turn special tool 2 414 691 at adjusting screw uniformly upwards, until the special tool 2 357 071 makes contact with the oil sump.
- Tighten all the adjusting screws of the special tools 2 414 691 and 2 357 071 .
CAUTION:
Residual pressure in the heating and air conditioning system
.
Injury hazard!
Injury hazard!
- Wear safety goggles and protective gloves when disconnecting the refrigerant line.
- Close the refrigerant lines with seal plugs.
- Thread out holder (1) and set aside.
- Unlock and loosen holder (2).
- Loosen screw (3).
- Feed out the refrigerant line (4) and put to one side.
- Seal refrigerant line (4) using commercially-available seal plug.
- Replace the sealing ring (1) on the refrigerant line (2).
Parts: Sealing ring
- Loosen screw (1).
- Thread out partition wall (2) and place to one side.
- Loosen screw (3).
- Feed out the refrigerant line (4) and put to one side.
- Unlock and loosen holder (1).
- Feed out the refrigerant line (2) and put to one side.
- Loosen screw (3).
- Loosen screw (1).