Checking the end stops of the electrical wastegate valve controller

• Carry out the following steps only if the check for the end stops of the electrical wastegate valve controller is predefined by the vehicle diagnosis.
• Connect diagnostic system:

• Service functions
• Power train
• Engine electrical system
• Adjustment programs
• Checking the end stops of the wastegate linkage

Follow-up work 

• Refer to INSTALLING THE HEAT SHIELD ON THE EXHAUST TURBOCHARGER, TOP .
• Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
• Refer to INSTALLING LAMBDA OXYGEN SENSOR .
• Refer to INSTALLING BATTERY CARRIER .
• Refer to INSTALLING E-BOX .
• Refer to INSTALLING THE SYSTEM BATTERY .
• Refer to CONNECTING BATTERY GROUND LEAD .
• Refer to PREPARING FOR THE INSTALLATION OF THE CLEAN AIR PIPE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING THE REAR BULKHEAD .
• Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
• Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE REAR HOOD SEAL .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING INTAKE SILENCER HOUSING .
• Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
• Refer to INSTALLING THE FRONT RIGHT WHEEL .