Installing acoustic cover

NOTE: RISK OF DAMAGE
Damage to the acoustic cover/design cover .
Jerky movements during disassembly and application of excessive force during installation may result in breakage of the acoustic cover/design cover .

Disassemble or mount the acoustic cover/design cover carefully.
Disassemble or mount snap-lock couplings of the ball pivots one after the other.
Disassemble or mount the acoustic cover/design cover only at temperatures > 20°C.
Use only distilled water as an auxiliary material during installation, no lubricants.

Check

Check correct fit of the rubber mounts (1) in the acoustic cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Rubber mounts (1) are not seated correctly in the stands.

Measure
- Insert the rubber mounts (1) correctly.
Set and engage the acoustic cover (1) on the locating pin in the marked areas.

» The acoustic cover (1) must engage noticeably and audibly.

Courtesy of BMW OF NORTH AMERICA, INC.