Install the DSC control unit
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Connect DSC control unit carefully to hydraulic unit.
- Replace screws (1)
to (3)
.
Parts: Screws
- Tighten screws (1) to (3) in this order in stages.
TIGHTENING TORQUE SPECIFICATIONS
| DSC control unit on hydraulic unit | ||
| Screw Replace screws. Screw in screws and evenly tighten crosswise. |
Tightening torque | 5.5 Nm |
- Install holder (2) .
- Insert screws (1) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic control unit to holder | ||
| M6 Replace screws. |
Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING HYDRAULIC UNIT .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to INSTALLING THE REAR COWL PANEL .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .