Install right clean air pipe
- Check the seal (1) in the turbocharger and replace if necessary.
- Insert the clean air pipe (2) and mount it to the turbocharger.
- Tighten down screws (1)TIGHTENING TORQUE SPECIFICATIONS
Clean air pipe to turbocharger M6 Tightening torque 10 Nm - Connect and audibly lock the ventilation line (3) on the clean air pipe (4).
- Replace sealing rings.
Parts: Sealing ring
- Mount the oil feed line (2) with the new sealing rings and the banjo bolt (1) on the cylinder head.
- Tighten the banjo bolt (1).
TIGHTENING TORQUE SPECIFICATIONS
| Oil feed line on cylinder head | ||
|---|---|---|
| Banjo bolt M14 Replace banjo bolt and seals | Joining torque | 15 Nm |
| Angle of rotation | 60° | |
Follow-up work
- Refer to MOUNTING THE ALTERNATOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR 2 AND THE AIR CONDITIONING COMPRESSOR .
- Refer to CHECKING THE DRIVE BELT FOR ALTERNATOR 2 .
- Refer to REMOVING THE PROTECTIVE PLATE AT THE RADIATOR .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING LEFT INTAKE PORT .
- Refer to INSTALLING RIGHT AIR DUCT .
- Refer to INSTALLING THE LEFT-HAND AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FANFARE HORN, RIGHT .
- Refer to INSTALLING THE FANFARE ON THE LEFT SIDE .
- Refer to INSTALLING THE CENTER TOP CROSS CONNECTION .
- Refer to INSTALLING BOTH HEADLIGHTS .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING FRONT SECTION OF THE FRONT WHEEL ARCH COVER (PARTIALLY REMOVED) .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE ACTIVE STABILIZER IN FRONT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING FRONT STIFFENING PLATE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ADJUSTING HEADLIGHTS .